ASTM A684/A684M - 25

1.1 This specification covers cold-rolled, high-carbon strip in coils or cut lengths. Strip is classified as product that is 0.300 in. [7.50 mm] or less in thickness and over ¹/₂ in. to 23 ¹⁵/₁₆ in. [12.5 mm to 600 mm] in width, inclusive. Strip products may be available in thicknesses greater than 0.300 in. [7.50 mm], widths ¹/₂ in. [12.5 mm] and narrower, or widths wider than 23¹⁵/₁₆ in. [600 mm], however the tolerances are based on agreement between purchaser and supplier. The maximum of the specified carbon range is over 0.25 % to 1.35 %, inclusive. It is furnished in the following types as specified:

1.2 This specification is applicable for orders in either inch-pound units or SI units.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 The tolerances in this specification are different than those in Specification A568/A568M and Specification A109/A109M.

1.5 For the purpose of determining conformance with this specification, values shall be rounded to the nearest unit in the right hand place of figures used in expressing the limiting values in accordance with the rounding method of Practice E29.

1.6 This specification is expressed in both inch-pound units and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units. The metric portions of the tables herein list permissible variations in dimensions and mass (see Note 1) in SI (metric) units. The values listed are not exact conversions of the values listed in the inch-pound tables but instead are rounded or rationalized values. Conformance to SI tolerances is mandatory when the “M” specification is used.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.