ASTM A890/A890M - 18a
Standard Specification for Castings, Iron-Chromium-Nickel-Molybdenum Corrosion-Resistant, Duplex (Austenitic/Ferritic) for General Application
¿Abrumado/a por la IA?
Pasa de la teoría a la práctica con el Taller de IA: Fundamentos Prácticos y Maestría. Próximo 4 de Junio
¡RESERVA TU PLAZA AQUÍ!| Aviso: | Las normas ASTM en lectura se visualizan a través del área de cliente. Los archivos no se pueden descargar |
|---|---|
| Fecha edición: |
2018-09-01
Anulada
|
| Fecha cancelación: | 2018-09-01 |
| Idiomas disponibles: | Inglés |
| Resumen: | This specification covers castings, iron-chromium-nickel-molybdenum corrosion-resistant, duplex(austenitic/ferritic) for general application. Castings shall be heat treated in accordance with the required procedure and heat-treat temperature. Proper heat treatment of these alloys is usually necessary to enhance corrosion resistance and in some cases to meet mechanical properties. Minimum heat-treat temperatures are specified; however, it is sometimes necessary to heat-treat at higher temperatures, hold for some minimum time at temperature and then rapidly cool the castings in order to enhance the corrosion resistance and meet the required mechanical properties. The steel shall conform to the required chemical composition for carbon, manganese, silicon, phosphorus, sulfur, chromium, nickel, molybdenum, copper, tungsten, and nitrogen. Castings shall be marked for material identification with the specification designation and grade. |
| Keywords: | austenite; duplex stainless steel; ferrite; stainless steel; steel castings; |
| Scope: | 1.1 This specification covers a group of cast duplex stainless steels (austenitic/ferritic). 1.2 The duplex stainless steel alloys offer a combination of enhanced mechanical properties and corrosion resistance when properly balanced in composition and properly heat treated. Ferrite levels are not specified, but these alloys will develop a range of approximately 30 to 60 % ferrite with the balance austenite. It is the responsibility of the purchaser to determine which grade shall be furnished depending on design and service conditions, mechanical properties, and corrosion-resistant characteristics. Note 1: Because of the possibility of precipitation of embrittling phases, the grades included in this specification are not recommended for service at temperatures above 600 °F [315 °C]. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3.1 Within the text, the SI units are shown in brackets. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 77.140.80 - Fundición y acero moldeado |
| CTN: | A01.18 - A01.18 |
|
Anulaciones Normas |
Anula a A0890_A0890M-18 |
|
Otras Relaciones |
Es referenciada por A0743_A0743M-21 Es referenciada por A0957_A0957M-21 Es referenciada por A0781_A0781M-21 Es referenciada por F0998-12R22 Es referenciada por A0488_A0488M-24 |
Normas citadas
Libros relacionados
Normas relacionadas
Otras colecciones temáticas
