ASTM D75/D75M - 19(2026)
Standard Practice for Sampling Aggregates
| Aviso: | Las normas ASTM en lectura se visualizan a través del área de cliente. Los archivos no se pueden descargar |
|---|---|
| Fecha edición: |
2026-05-01
En Vigor
|
| Idiomas disponibles: | Inglés |
| Resumen: | |
| Keywords: | aggregates; exploration of potential sources; number and sizes needed to estimate character; sampling; |
| Scope: | 1.1 This practice covers sampling of coarse and fine aggregates for the following purposes: 1.1.1 Preliminary investigation of the potential source of supply, 1.1.2 Control of the product at the source of supply, 1.1.3 Control of the operations at the site of use, and 1.1.4 Acceptance or rejection of the materials. Note 1: Sampling plans and acceptance and control tests vary with the type of construction in which the material is used. 1.2 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. Note 2: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| ICS: | 91.100.30 - Hormigón y productos de hormigón |
| CTN: | D04.30 - D04.30 |
|
Otras Relaciones |
Es referenciada por C330/C330M - 23 Es referenciada por C144 - 25 Es referenciada por C535 - 16(2024) Es referenciada por D5821 - 13(2025) Es referenciada por C127 - 25 Es referenciada por D8249 - 19(2024) Es referenciada por C1077 - 26 Es referenciada por D3987 - 12(2020) Es referenciada por D8038 - 16(2022)e1 Es referenciada por C29/C29M - 23 Es referenciada por C1451 - 24 Es referenciada por C87/C87M - 23 Es referenciada por C332 - 23 Es referenciada por D1865/D1865M - 09(2023) Es referenciada por D1073 - 16(2022) Es referenciada por D8012 - 18 Es referenciada por E1109 - 19 Es referenciada por D2940/D2940M - 20 Es referenciada por D6932/D6932M - 26 Es referenciada por C566 - 25 |
Normas citadas
Libros relacionados
Normas relacionadas
Colecciones temáticas relacionadas
