Using Artificial Intelligence (AI) on ASTM standards and related intellectual property is prohibited. Violations will result in suspension of access.
Escribe aquí el texto del aviso...test1
Escribe aquí el texto del aviso...test5 (no permite cerrarlo)
Escribe aquí el texto del aviso...test2
Escribe aquí el texto del aviso...test3
DIN EN 12341:2023-10
Ambient air - Standard gravimetric measurement method for the determination of the PM<(Index)10> or PM<(Index)2,5> mass concentration of suspended particulate matter; German version EN 12341:2023
| Fecha edición: |
2023-10-01
En Vigor
|
|---|---|
| Idiomas disponibles: | Inglés, Alemán |
| Resumen: | This European Standard describes a standard method for determining the PM10 or PM2,5 mass concentrations of suspendedparticulate matter in ambient air by sampling the particulate matter on filters and weighing them by means of a balance.Measurements are performed with samplers with inlet designs as specified in Annex A, operating at a nominal flow rate of 2,3 m3/h,over a nominal sampling period of 24 h. Measurement results are expressed in ?g/m3, where the volume of air is the volume atambient conditions near the inlet at the time of sampling.The range of application of this European Standard is for 24 h measurements from approximately 1 ?g/m3 (i.e. the limit of detection ofthe standard measurement method expressed as its uncertainty) up to 150 ?g/m3 for PM10 and 120 ?g/m3 for PM2,5.This European Standard describes procedures and gives requirements for the testing and use of so-called sequential samplers,equipped with a filter changer, suitable for extended stand-alone operation. Sequential samplers are commonly used throughout theEuropean Union for the measurement of concentrations in ambient air of PM10 or PM2,5. However, this European Standard does notexclude the use of single-filter samplers.This European Standard represents an evolution of earlier European Standards (EN 12341:1998 and 2014, EN 14907:2005). Newequipment procured shall comply fully with this European Standard.Older versions of these samplers, including those described in EN 12341:2014 Annex B, have a special status in terms of their use. These samplers can still be used for monitoring purposes and for ongoing quality control, provided that a well justified additionalallowance is made to their uncertaintiesThis European Standard also provides guidance for the selection and testing of filters with the aim of reducing the measurementuncertainty of the results obtained when applying this European Standard. |
| Keywords: | Air|Air purification|Air quality|Airborne dust|Ambient air|Comparison|Composition|Definitions|Dust|Dust contents|Environment (working)|Field investigations|Gravimetric analysis|Health hazards|Health protection|Instruments|Mass concentration|Measurement|Methods|Particle size|Particulate matter measurement|Reference measuring methods|Reference methods|Sampling methods|Suspended dust|Test equipment|Test results|Testing|Working places|Workplace safety |
| ICS: | 13.040.20 - Aire ambiente |
| CTN: | |
|
Equivalencia Internacional |
Idéntica EN 12341:2023 |
|
Reemplazo Normas |
Reemplaza a DIN EN 12341:2014-08 Reemplaza a DIN EN 12341:2022-06 |
Normas citadas
Libros relacionados
Normas relacionadas
Colecciones temáticas relacionadas
