DIN EN 13476-3:2026-06
Plastics piping systems for non-pressure underground drains and sewers - Structured-wall piping systems of unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) - Part 3: Specifications for pipes and fittings with smooth internal and profiled external surface and the system, Type B; German version EN 13476-3:2025
| Fecha edición: |
2026-06-01
En Vigor
|
|---|---|
| Idiomas disponibles: | Alemán |
| Resumen: | This document, together with EN 13476-1, specifies the definitions and requirements for pipes, fittings and the system based on unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) structured-wall piping systems that are intended for use in non-pressure underground drains and sewers for foul wastewater. NOTE 1 Products complying with this document can also be used in non-pressure underground drains and sewers for surface water. This document is applicable to pipes and fittings with smooth internal and profiled external surfaces, designated as Type B. This document also specifies test methods and test parameters. This document is applicable to: a) structured-wall pipes and fittings, which are intended to be used buried underground outside the building structure, reflected in the marking of products by "U"; and b) structured-wall pipes and fittings, which are intended to be used buried underground both outside (application area code "U") and within the building structure, reflected in the marking of products by "UD". This document is applicable to structured-wall pipes and fittings with or without an integral socket with elastomeric ring seal joints as well as welded and fused joints. This document is applicable to a range of pipe and fitting sizes, materials, pipe constructions, stiffness classes, application areas, tolerance classes and gives recommendations concerning colours. NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. |
| Keywords: | Classification|Determination|Fittings|Interior surface|Marking|Materials|Mouldings (shaped section)|Outer surfaces|PE|Pipelines|Pipes|Piping system|Piping test|Plastic pipelines|Plastic pipes|Plastics|Polyethylene|Polypropylene|Polyvinyl chloride|PP|Procedures|Profiled|Properties|Protective tubes|PVC-U|Sealing rings|Sewerage|Sewers|Side|Sleeves|Specification (approval)|Symbols|Testing|Thermoplastic polymers|Underground|Unplasticized polyvinyl chloride |
| ICS: | 23.040.01 - Canalizaciones y accesorios en general, 93.030 - Sistemas exteriores de evacuación de aguas residuales |
| CTN: | |
|
Equivalencia Internacional |
Idéntica EN 13476-3:2025 |
|
Reemplazo Normas |
Reemplaza a DIN EN 13476-3:2020-12 Reemplaza a DIN EN 13476-3:2024-03 |
Normas citadas
Libros relacionados
Normas relacionadas
Colecciones temáticas relacionadas
