DIN EN 1501-3:2025-08
Refuse collection vehicles - General requirements and safety requirements - Part 3: Front loaded refuse collection vehicles; German and English version prEN 1501-3:2025 / Note: Date of issue 2025-06-27*Intended as replacement for DIN EN 1501-3 (2021-05).
| Fecha edición: |
2025-08-01
En Vigor
|
|---|---|
| Idiomas disponibles: | Alemán, Inglés |
| Resumen: | This document applies to a front loaded refuse collection vehicle (RCV), as defined in 3.2, regardless of the power drive. This document deals with all significant hazards, hazardous situations and events relevant to the front loaded RCV, when it is used as intended and under conditions of misuse which are reasonably foreseeable, throughout its foreseeable lifetime, as defined in Clause 4. This document is applicable to the design and construction of the front loaded RCV so as to ensure that it is fitted for its intended function and can be operated, cleaned (including unblocking), adjusted and maintained during its entire lifetime. It is not applicable to the end of life of the front loaded RCV. This document describes and defines the safety requirements of the front loaded RCV excluding the interface with the lifting device(s) and excluding the lifting device itself and excluding loader cranes, which could be mounted on the RCV. Lifting device(s), loader cranes and their interface to the RCV are covered in EN 1501-5:202X. Loader cranes are covered in EN 12999:2020 and those installed on RCVs are covered in EN 1501-5:202X. This document also applies to compactors, operated on a truck for collecting purposes. This document is not applicable to: operation in severe conditions, e. g. extreme environmental conditions such as: below ?20 °C and above +40 °C temperatures; tropical environment; wind velocity in excess of 75 km/h; contaminating environment; corrosive environment; operation in potentially explosive atmospheres; handling of loads the nature of which could lead to dangerous situations (e. g. hot refuses, acids and bases, radioactive materials, contaminated refuse, especially fragile loads, explosives); operation on ships. The revision of EN 1501-1/-2-/3 and -5:2021 was necessary in particular due to the new Machinery Regulation 2023/1230, which contains new and revised essential health and safety requirements (EHSRs). This document is prepared by Technical Committee CEN/TC 183 "Waste management", the secretariat of which is held by DIN. |
| Keywords: | Bodies|Chassis|Classification|Collections|Communal purposes|Communication|Compacting|Control|Definitions|Design|Discharge|Discharge device|Dumps|Electrical equipment|Electrical safety|Explosion hazard|Explosions|Footboard|Front loaders|Graphic symbols|Hydraulics|Impact|Lay|Lighting systems|Loaders|Maintenance|Materials|Materials of value|Mechanical crimping|Noise|Noise (environmental)|Noise reduction|Operating instructions|Public service vehicles|Rear-end loaded refuse collection vehicles|Recycling|Refuse collection vehicles|Refuse disposal|Risk of stumbling|Safety|Safety of machinery|Safety requirements|Sound|Specification (approval)|Stability|Sumps|Symbols|Testing|Transport|Usage|Vehicles|Waste collection|Wastes |
| ICS: | 43.160 - Vehículos especiales |
| CTN: |
Normas citadas
Libros relacionados
Normas relacionadas
Colecciones temáticas relacionadas
