DIN EN 1501-5:2025-08
Refuse collection vehicles - General requirements and safety requirements - Part 5: Lifting devices for refuse collection vehicles; German and English version prEN 1501-5:2025 / Note: Date of issue 2025-06-27*Intended as replacement for DIN EN 1501-5 (2021-05).
| Fecha edición: |
2025-08-01
En Vigor
|
|---|---|
| Idiomas disponibles: | Alemán, Inglés |
| Resumen: | This document deals with all significant hazards, hazardous situations and events relevant to lifting devices used for the emptying of designated refuse containers into RCVs and their fitting onto the RCVs when they are used as intended and under conditions of misuse which are reasonably foreseeable throughout their foreseeable lifetime as defined in Clause 4. This document is applicable to the design and construction of the refuse container lifting devices and the mounting of other lifting devices so as to ensure that they are fitted for their function and can be operated, adjusted and maintained during their entire lifetime. It is not applicable to the end of life of the lifting devices. This document describes and gives the safety requirements of the lifting devices for emptying refuse containers and their interfaces with the corresponding parts of the RCVs and will be used in conjunction with EN-1501-1:202X for the rear, side and front loaded RCVs. It refers to EN 1501-4:2023 for the noise test code. This document is not applicable to: operation in severe conditions e. g. extreme environmental conditions such as: temperatures below ?20 °C and above +40 °C; tropical environment; wind velocity in excess of 75 km/h; contaminating environment; corrosive environment; operation in potentially explosive atmospheres; lifting and transportation of persons; emptying refuse containers other than those manufactured according to EN 840:2020 (all parts), EN 12574:2017 (all parts), EN 13071:2019 (all parts), and those described as paladin, diamond, skip containers; loading bulky refuse by means of platform or forks; handling of loads the nature of which could lead to dangerous situations (e. g. hot refuses, acids and bases, radioactive materials, contaminated refuse, especially fragile loads, explosives); operation on ships; fitting and operation on stationary compactors. The revision of EN 1501-1/-2-/3 and -5:2021 was necessary in particular due to the new Machinery Regulation 2023/1230, which contains new and revised essential health and safety requirements (EHSRs). This document is prepared by Technical Committee CEN/TC 183 "Waste management", the secretariat of which is held by DIN. |
| Keywords: | Bodies|Chassis|Classification|Collections|Communal purposes|Communication|Compacting|Control|Definitions|Design|Discharge|Discharge device|Dumps|Electrical equipment|Electrical safety|Explosion hazard|Explosions|Footboard|Front loaders|Graphic symbols|Hydraulics|Impact|Lay|Lifting devices|Lighting systems|Loaders|Maintenance|Materials|Materials of value|Mechanical crimping|Noise|Noise (environmental)|Noise reduction|Occupational safety|Operating instructions|Public service vehicles|Rear-end loaded refuse collection vehicles|Recycling|Refuse collection vehicles|Refuse disposal|Risk of stumbling|Safety|Safety of machinery|Safety requirements|Side loaded vehicles|Sound|Specification (approval)|Stability|Sumps|Symbols|Testing|Transport|Usage|Vehicles|Waste collection|Waste management|Wastes|Workplace safety |
| ICS: | 43.160 - Vehículos especiales |
| CTN: |
Normas citadas
Libros relacionados
Normas relacionadas
Colecciones temáticas relacionadas
